Argo AES Series Bedienerhandbuch PDF herunterladen (Seite 201)

201

-Modell - 11/12 - Ausgabe 09/11 - 2096161 - BUE-0036-10EN

Maintenance

 Close bleeding valve.

 Repeat this procedure at all bleeding valves.

 Check to see if the hot-water heater warms up.

12.6.4 Position of the bleeding valves

12.7 Independent vehicle heater

Use the independent vehicle heater for 10 minutes at least once a month with

a cold engine and smallest fan settings.

Before the heating season starts, have the independent vehicle heater

checked by an authorised specialist workshop.

12.8 Replacing bulbs, external

Types of bulbs Different types of bulbs are used in the vehicle. Below, we have described how

to change the different types of bulbs.

Position of the bleeding valves

A 747-2

Drain for complete emptying under the garage flap under the vehicle at the right

On the overcab bed, right and left

In the seating group away from the direction of travel, access via the bench seat

cover

In the divan in the front area, access via the service flap

In the cabinet at the left access

In the bathroom on the radiator

On the rear bed, left and right

In the kitchen behind the drawer

In the rear to the right, access via the garage flap

X Bulbs and light fittings can be extremely hot. Therefore, allow lights to

cool down before changing bulbs.

X Store bulbs in a safe place inaccessible to children.

X Do not use any bulb that has been dropped or which shows scratches in

its glass. The bulb might burst.

Z A new bulb should not be touched with the fingers. Use a cloth when

installing the new bulb.

Z Use only bulbs of the same type and with the correct wattage (see table

"Types of bulbs for exterior lighting").

Z If LEDs in lights are defect, contact an authorised dealer or service centre.

1 2 ... 196 197 198 199 200 201 202 203 204 205 206 ... 261 262

Keine Kommentare

Argo AES Series Bedienerhandbuch Seite 201